sudo apt-get install exfat-fuse exfat-utilsīefore you go forward, also create a mount point. Before going forward, you must understand that this is not permanent, but could cause problems if there are programs dependant on this drive. This allows the system to perform the action before anything else is active. To mount the drive on boot, it is recommended that you use fdisk. When you are done, you may want to run sudo shutdown -r for a reboot.ġ x Raspberry Pi - Min requirements: ARM7 processor or betterġ x WiFi Network connection, or Ethernet Connection (if wifi is embedded don't worry about it)ġ x External Hard Drive or NAS formatted in a UNIX friendly FileSystem Note: ensure you have formatted the external hard drive in one of the following ways: NTFS, exFAT, or Extended Linux. A note for those who may be oblivious: This will not support transcoding, as it is not a powerful server, so make sure all of your media is encoded in the appropriate codec for multi-device playback. I have down this 4 times, and has worked every time. To answer you first question: Plex can be installed without the OS RasPlex installed (RasPlex is actually a client, not a server).Īll that is needed is Raspbian (I did it on Jessie 8), and a few instructions to be followed, which are included below.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |